I finally solved the overheating problem with the GoPro MISSION1 PRO ILS.
There were three issues I wanted to solve with the MISSION1:
Recording interruptions caused by overheating
No built-in viewfinder
No way to attach a camera strap
Since overheating was the only issue affecting my microscope photography, I decided to tackle that problem first.
I tried various cooling methods, including attaching heat sinks, cooling fans, and even a Peltier-based smartphone cooler.
After experimenting with several solutions, I finally found an excellent cooling fan.
It's the gray component shown in the photos.
The cooler is installed after removing the MISSION1's battery door.
The hottest part of the MISSION1 is the area behind the lens.
During recording, the temperature in this area exceeds 70°C.
This cooler is designed to be used with the camera's battery removed.
Both the camera and the cooling fan are powered through a single USB-C cable.
The fan works by extracting hot air from inside the camera.
Its clever design separates the space inside the battery compartment into intake and exhaust passages, allowing heat to be removed very efficiently.
It's an excellent cooling solution!
The cooler is available on Amazon and AliExpress.
Although the product description doesn't mention compatibility with the MISSION1, it fits perfectly because the MISSION1 uses the same battery door design as the GoPro HERO series.
Solving the Viewfinder and Strap Problems
I solved the remaining two problems using a 3D printer.
I designed and printed a mounting bracket for the JGGLD ST1, an external viewfinder designed for cameras without a built-in viewfinder.
The JGGLD ST1 features diopter adjustment and normally attaches to the tripod socket on the bottom of the camera.
However, the JGGLD ST1 is made of plastic, and when attached directly to the MISSION1 with a heavy lens mounted, it bends under the weight, making it awkward to use.
Another problem is that the height of the JGGLD ST1 does not align properly with the MISSION1's rear monitor when mounted directly.
To solve these problems, I designed a custom mounting bracket that also serves as a lens support.
I also incorporated strap attachment points into the bracket.
Thanks to the lens support, the camera is now much easier and more comfortable to hold.
Cooling Performance
With this setup, I was able to record continuously at 4K 240 fps for more than 20 minutes!
There is, however, one drawback.
When the cooling fan is running, its noise is picked up by the camera's microphone.
The recorded audio sounds like someone is vacuuming nearby—or like a live broadcast from a helicopter!
In my case, this isn't a problem because I don't need audio when shooting high-speed video.
The cooling fan also has an ON/OFF switch, so I can simply turn it off whenever I need to record clean audio.
Using the MISSION1 for Microscope Photography
When using the MISSION1 with a microscope, I connect it to an external monitor through a USB-C hub with HDMI output.
I'll introduce that setup in my next article.



Comments
Post a Comment